Elastic sleeves stretch out and slide down mid-set. This brace stays anchored with a stabilizing patella ring, four spring-steel side stays, and dual straps you tighten independently — so support stays exactly where you put it, rep after rep.
Slide-on sleeves stretch out within a week and roll down mid-set. Rigid hinge braces stay put, but they fight the knee's natural bend — so you end up fighting the brace instead of your workout. This one is built around a stabilizing patella ring and spring-steel side stays that flex with the joint, plus straps you tighten independently above and below it, so the brace disappears into the movement instead of interrupting it.
SEVEN DESIGN DECISIONS
One adjustable size, Model #911 — fits 35–52cm (13.78–20.47in) leg circumference.
Removes direct pressure from the kneecap during bending
Woven ring keeps the kneecap centered through motion
Two flexible stays per side resist lateral shift
Adjust above and below the joint independently
Ventilated fabric cuts down on heat buildup during long wear
Inner grip band keeps the brace from sliding down
Stitched borders hold their shape, wash after wash
Open the straps and lay the brace flat, patella cutout facing up.
Slide it over your foot and up to the knee, centering the opening over your kneecap.
Pull the fabric snug so the patella ring sits directly over the joint.
Secure the lower strap first, then the upper strap, adjusting each for even pressure.
Test it with a few steps or a shallow squat before you start your activity.
If the ring drifts to one side during that test, loosen both straps and recenter the brace before tightening again.
Open patella with stabilizing ring
Four spring-steel stays (two per side)
Dual adjustable hook-and-loop straps
Perforated, breathable knit fabric
One size, adjustable — Model #911, fits leg circumference 35–52cm (13.78–20.47in), recommended for users 45–100kg (about 99–220 lb)
Running, weightlifting, court sports, hiking, everyday joint support
1 knee brace
Hand wash cold, air dry flat
A closed sleeve presses fabric directly against the kneecap, and that pressure only builds as the knee bends. Cutting the fabric away and adding a stabilizing ring around the opening moves the load to the sides of the joint instead, where the four spring stays are built to carry it. Springs flex with a bent knee; a rigid hinge doesn't — which is why so many stiff braces get loosened mid-workout just to make bending tolerable. The trade-off here is deliberate: less material over the kneecap, more structure around it.
Spring stays, two per side, for balanced lateral support
Straps, adjusted independently above and below the joint
Not satisfied? Full refund, no questions asked.
Dispatched within 24 hours of your order.
Confirmation email in minutes
Packed and dispatched within 24 hrs
Tracked to your door
It's slim enough for athletic leggings and most looser pants, though snug jeans may feel tight over the straps.
The design is symmetrical, so the same brace works on either knee.
+
It's built for support and stability, not medical-grade immobilization. If you're managing a diagnosed injury or recovering from surgery, check with your doctor or physical therapist before relying on it.
No — it's one adjustable size (Model #911), fitting a leg circumference of 35–52cm (13.78–20.47in) and recommended for users between 45–100kg (about 99–220 lb). The dual straps let you fine-tune the fit within that range.
Hand wash is recommended — the spring stays and silicone strip can warp or loosen in a washing machine.
Move without checking on your knee. One brace, built to stay where you put it.
60-day money-back guarantee · Free shipping over $50 · Ships within 24 hrs